There is no better way to spend a Saturday than anchored at a sandbar with a fleet of friends. It is the peak of sandbar life, but let us be real: watching a group of amateurs try to tie up is often more entertaining than the actual party. If you want to avoid being the person who puts a cleat through their neighbor’s gelcoat or causes a mid-water brawl, you need to treat the raft up with a little bit of respect. Nobody buys a boat because they wanted another sensible financial decision, but you should at least try to keep your hull in one piece.
The Golden Rule: The Anchor Boat
Before you even think about pulling alongside, designate a raft captain. The largest, heaviest boat in the group should be the anchor boat. This vessel serves as the foundation for the entire raft. Once that anchor is set and holding firm, everyone else ties to them. Do not get cute and drop your own anchor once you are tied up. If every boat in the raft has an anchor down, you are going to be fighting the wind and current in different directions, which is a recipe for snapped lines and damaged rub rails. Let the lead boat do the heavy lifting.
The Approach and The Tie-Up
Approach the anchor boat slowly from behind. Keep your eyes peeled for swimmers and other boaters who might be drifting in your blind spot. Once you are in position, align your swim platforms. It makes moving between boats significantly easier and keeps the social flow going. When you are ready to secure the lines, use your cleats. Never tie off to handrails, ski tows, or random deck hardware that was not designed to take the load of a boat. If you rip a railing off, you are going to have a very bad time. Use high-quality, stretchable nylon lines. Avoid non-stretch ropes, as they create jarring loads that will eventually tear your cleats right out of the fiberglass. For boats up to 27 feet, a 3/8 inch line is standard, but bump up to 1/2 inch for anything between 28 and 35 feet to ensure you have the strength to handle the surge.
The X-Factor: Spring Lines
If you are just tying bow-to-bow and stern-to-stern, you are doing it wrong. You need spring lines. Run your lines diagonally between the boats to form an X shape. This is the secret to a stable raft. These lines control the fore-and-aft motion, ensuring that when a wake rolls through, the boats move as a single unit rather than banging against each other like bumper cars. If your fenders are rolling out or your boats are jerking, your lines are too loose. Tighten them up until the raft feels like one solid island. Proper spring lines should have just enough slack to allow for movement without letting the hulls make contact.
Etiquette and Safety
Check your ego at the dock. If you are heading over to another boat, make sure your feet are clean. Nobody wants a pile of sand ground into their upholstery. Also, be mindful of your exhaust. Carbon monoxide is a silent killer, and in a tight raft, exhaust buildup is a real risk. Keep your engines off and your generators vented away from the group. Finally, have an exit plan. The last boat in should be the first one out. If you are in the middle of a five-boat raft, you are stuck until your neighbors move. Keep the boat safety basics in mind, keep your fenders deployed, and keep the drama on the shore where it belongs. If you are looking to upgrade your gear before the next outing, check out our accessories to ensure you are ready for the season.
Ready To Find Your Boat?
Our local boating partner, Munson Ski & Marine, is minutes from the Chain O’ Lakes. Explore pontoon and tritoon boats for sale or see Munson Ski & Marine. The Walworth, WI showroom is a short drive from Lake Geneva boaters.













