CHRISTMAS DEADLINE: ORDER BY DEC 9 — FREE US SHIPPING ON EVERY ORDER

Boat Maintenance

The Spring Commissioning Checklist: Don't Be That Guy at the Ramp

Don't be the guy blocking the ramp. Our no-nonsense spring commissioning guide covers the fuel, engine, and safety checks you need to hit the water.

By Dock Feral CrewPosted Oct 13, 2026Updated 2026-10-23T18:06:40.4090006 Min Read
Dock Feral crew wearing the Dock Feral Black Flag Boat Club Hoodie on the lake
Dock Feral crew wearing the Dock Feral Black Flag Boat Club Hoodie on the lake

Nobody buys a boat because they wanted another sensible financial decision. We buy them for the sunsets, the sandbars, and the ability to escape the land-locked masses. But before you can start making questionable nautical choices, you have to survive the annual rite of spring commissioning. If you skip this, you are just asking for a tow-boat ride on your first weekend out, and nobody wants to be that guy blocking the ramp for forty-five minutes while their outboard refuses to crank. Getting your vessel ready for the season is about protecting your investment and your weekend. Before you even think about backing down the ramp, run through this list to ensure your boat is actually ready for the season.

The Engine and Fuel System

The heart of your boat has been sitting idle for months, likely with ethanol-blended fuel slowly absorbing moisture. If your fuel lines are older than three years, specifically those marked with SAE J1527, replace them; they are likely brittle and prone to internal delamination. Empty your portable 6-gallon plastic tanks completely rather than trying to treat last year’s leftovers. For fixed tanks, replace the primary fuel/water separator filter, such as a Sierra or Racor 10-micron element. If you are running a Mercury Verado or Yamaha F250, pay close attention to your zinc anodes. If more than 50 percent of the material has dissolved, replace them immediately to avoid galvanic corrosion on your lower unit. Inspect the raw water impeller; if it has more than 100 hours or three years on it, it has developed a set that will eventually lead to overheating at high RPM. Charge your batteries to 12.6 volts or higher. Remove the wing nuts, clean the terminals with a wire brush, and coat them with dielectric grease to prevent the oxidation that causes that dreaded click-click at the ramp. For inboard and sterndrive owners, every few years you must remove and inspect exhaust manifolds and risers for corrosion, as these are the silent killers of marine engines.

Hull and Safety Gear

Before you launch, replace any dock lines showing visible signs of chafe or core exposure, especially if you are mooring a boat over 25 feet. Inspect your anchor rode; if your nylon line has stiffened, the fibers have likely begun to break down from UV exposure. Verify your USCG-required safety gear: check that your fire extinguishers are charged with the gauge in the green zone, and ensure your flares have not expired, as they are typically only rated for 36 to 42 months. Once you are in the water, the very first thing you must do is check all thru-hulls for weeping seals. It sounds obvious, but a brass drain plug missing its O-ring can let in upwards of 5-10 gallons of water per minute if a hose fails. Keep your boat safety gear updated, including life jackets for every passenger, ensuring they are free of tears or mildew. If your electronics, like your Garmin GPSMAP or Simrad displays, show a low voltage warning during start-up, you have a battery or ground issue that needs attention before you go miles offshore. For those who spend their time chasing fish, ensure your fishing gear is organized and your livewell pumps are cycling water properly.

The Shakedown Cruise

Once everything is checked, do not head straight for the horizon. Take the boat out for a 20-minute shakedown cruise at a no-wake speed, then gradually ramp up to cruising speed, usually around 3,500 to 4,000 RPM. Monitor your engine temperature, which should stabilize between 140 and 160 degrees Fahrenheit. Listen for harmonic vibrations that indicate a bent prop or a fouled bearing. If everything sounds and feels right, you are ready to head to the sandbar and enjoy the season. If you find yourself needing a new look for the first trip of the year, check out our latest t-shirts and hats to make sure you look the part. For more deep dives into keeping your rig running, check out our boat maintenance guide.

Ready To Find Your Boat?

Our local boating partner, Munson Ski & Marine, is minutes from the Chain O’ Lakes. Explore boat dealership with four showrooms near the Chain O’ Lakes or see boats for sale. The Walworth, WI showroom is a short drive from Lake Geneva boaters.

Keep It Feral

More Boat Maintenance

Dock Feral crew wearing the Dock Feral Skull & Cross Hooks Hoodie on the lake

Boat Maintenance

Stern Drive Fluid Changes: Engine Oil, Gear Lube and When To Do Each

Nobody buys a boat for the maintenance, but keeping your sterndrive healthy is the only way to ensure you aren't stranded at the sandbar.

Oct 23, 2026 · 6 min

Dock Feral crew wearing the Mermaid Women's Crop Top on the lake

Boat Maintenance

Stern Drive Maintenance: Bellows, U-Joints and Impellers Before They Strand You

Your stern drive is the heart of your boat's performance. Neglect the rubber parts and you are asking for a tow. Here is how to stay ahead of the curve.

Oct 22, 2026 · 6 min

Dock Feral crew wearing the Dock Feral Wake Crew Hoodie on the lake

Boat Maintenance

Four-Stroke Annual Service Checklist: Everything Your Outboard Needs Each Year

Nobody buys a boat because they wanted another sensible financial decision, but you still need to keep the engine running. Here is your annual four-stroke service guide.

Oct 22, 2026 · 6 min

Dock Feral crew wearing the Dock Feral Send it Till Sunset Tee on the lake

Boat Maintenance

Four-Stroke Outboard Oil Change: The Complete DIY Guide

Stop paying dealership prices for basic maintenance. Here is how to handle your own four-stroke outboard oil change without the headache.

Oct 21, 2026 · 5 min

Dock Feral crew wearing the Dock Feral Plunder Your Weekend Tee on the lake

Boat Maintenance

Stern Drive Maintenance: The Complete Guide to Bellows, Fluids and Impellers

Stern drives reward attention and punish neglect. The complete guide to the bellows, gimbal bearing, u-joints, gear lube, impeller, and anodes that keep a sterndrive alive.

Oct 20, 2026 · 9 min

Dock Feral crew wearing the Dock Feral Black Flag Boat Club Hoodie on the lake

Boat Maintenance

Four-Stroke Outboard Care: The Complete Maintenance Guide

Four-stroke outboards are quiet, efficient, and utterly dependable as long as you actually maintain them. This is the complete care guide: oil, gear lube, impellers, plugs, and storage.

Oct 20, 2026 · 9 min

All Boat Maintenance Stories →